Filter
Top Products
3
USER GUIDE
Reset1
Status T°
1 X
1 X
Mode
Step
2 X
Mode
Store
1 X
Store
1 X
Stand
by
mode
Stand by mode
SETTING THE PARAMETERS
Setting the temperature of the hot water:
(Temperature of the hot water)
- Press “
Mode
”: “
PARA
” comes up on the screen.
- Press “
Step
”: the first digit is 1 and the last two digits indicate the
current temperature setting for the hot water.
- To change this temperature, press the “
+
” or “
-
” keys until the
temperature indicated by the last two digits is the desired
temperature.
- Press “
Store
” to save the setting.
- Press “
Mode
” twice to return to Standby mode (normal operating
mode).
Enabling and disabling hot water mode:
(hot water)
- Press “
Mode
”: “
PARA
” comes up on the screen.
- Press “
Step
” twice: the first digit is 2 and the last two digits
indicate the current setting:
00
= disabled;
01
= enabled.
- To change this parameter, press the “
+
” or “
-
” keys until you reach
the desired value:
00
= disabled;
01
= enabled.
- Press “
Store
” to save the setting.
- Press “
Mode
” twice to return to Standby mode (normal operating
mode).
Enabling and disabling central heating mode:
(heating)
- Press “
Mode
”: “
PARA
” comes up on the screen.
- Press “
Step
” three times: the first digit is 3 and the last two digits
indicate the current setting:
00
= disabled;
01
= enabled.
- To change this parameter, press the “
+
” or “
-
” keys until you reach
the desired value:
00
= disabled;
01
= enabled.
- Press “
Store
” to save the setting.
- Press “
Mode
” twice to return to Standby mode (normal operating
mode).
Setting the temperature of the central heating:
(the maximum temperature for the heating circuit)
- Press “
Mode
”: “
PARA
” comes up on the screen.
- Press “
Step
” four times: the first digit is 4 and the last two digits
indicate the current temperature setting for the central heating.
- To change this temperature, press the “
+
” or “
-
” keys until the
temperature indicated by the last two digits is the desired
temperature.
- Press “
Store
” to save the setting.
- Press “
Mode
” twice to return to Standby mode (normal operating
mode).
Fault:
The temperature setting of the appliance and the safety functions of its
parts are constantly monitored by a microprocessor controller (MCBA).
In the event of a fault, this MCBA disables the appliance and displays
an error code: the screen flashes and the first character is an “
E
”
followed by the fault code,
(see the list of faults on page 16).
Reset the appliance:
- Press “
Reset
” on the screen.
- If the fault code appears again, contact your installer.
Setting the temperature of the hot water
4 X
1 X
Mode
Step
2 X
Mode
Store
1 X
Store
1 X
Stand
by
mode
Stand by mode
Setting the temperature of the central heating
Fault Reset the appliance
3 X
1 X
Mode
Step
2 X
Mode
Store
1 X
Store
1 X
Stand
by
mode
Stand by mode
Enabling and disabling central heating mode
2 X
1 X
Mode
Step
2 X
Mode
Store
1 X
Store
1 X
Stand
by
mode
Stand by mode
Enabling and disabling hot water mode