Filter
Top Products
47
Heatilator •
HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12
13
13
Finishing
A. Finishing Templates
Two side fi nishing templates and one top fi nishing template
are supplied with the appliance. They are fastened to the
top surround.
INSIDE FIT Method: The fi nishing template pieces are
required for installations that require more than one inch
thick fi nishing materials to be installed over the face of the
factory-supplied 1/2 inch non-combustible board. Refer
to section 13.E for more information.
OVERLAP Method: The supplied templates are not
required for fi nishing materials less than one inch thick.
The required decorative front will overlap fi nish materials
less than one inch thick. Refer to section 13.E for more
information.
Note: For Arch Door applications with fi nish material
greater than one inch thick, an Arch Template Kit is
available. Contact your dealer to order the arch template
kit.
Template installation instruction
1. Determine if the required door options is a inoperable
(fi xed style) or operable (cabinet style). Doors denoted
with an FS are inoperable. Doors denoted with an
CS are operable. Refer to Section 13.E for door
information.
2. Bend the left and right side templates for the appropriate
door type using Figure 13.2 as a reference.
3. Locate the four threaded inserts on the inside edge of
the fi replace and secure the side templates with the
Phillips screws provided. See Figure 13.3.
4. Bend the top template as shown in Figure 13.1 and
secure with the two screws provided. The bend will
have two opposing 90 degree bends, similar to the
bends on the side templates.
5. Remove all template components once fi nishing
materials are secured.
INOPERABLE
DOORS
OPERABLE
DOORS
3/4 IN.
1-1/2 IN.
Figure 13.2 Left and Right Side Finishing Template Bends
TOP FINISHING
TEMPLATE
SIDE FINISHING
TEMPLATES
Figure 13.3 Top and Side Finishing Template Locations
Note: A thin layer of mortar may be applied over the
visible non-combustible board between fi nishing material
and the fi replace opening.
Figure 13.1 Top Finishing Template Bend
1-1/4 IN.
TAB
INOPERABLE DOORS - BEND DOWN
OPERABLE DOORS - DO NOT BEND DOWN