Heath Zenith 9700LeD Home Safety Product User Manual


  Open as PDF
of 20
 
3
598-1360-00
TESTING AND ADJUSTMENTS
1. Turn on the circuit breaker and light switch.
MotionMotion
NOTE:Ifxtureismountedhigherthan8ft.(2.4
m),aimingthesensordownwillreducecoverage
distance.
The detector is less sensitive to motion directly
towardsit.
Maximum Range Maximum
Coverage Angle
RANGE
1051TEST
ON-TIME
Bottom of Sensor
Avoid aiming the control at:
•Objectsthatchangetemperaturerapidly,suchas
heating vents and air conditioners.Theseheat
sourcescouldcausefalsetriggering.
•Areaswherepets or trafficmaytriggerthecon-
trol.
•Nearby large, light-colored objects reecting
lightmaytriggertheshut-offfeature.Donotpoint
otherlightsatthesensor.
70ft.
(21m)
8ft.
(2.4m)
180°
MIN MAX
Least Sensitive Most Sensitive
Sensor
3. Loosen the clamp screw
inthesensorballjointand
gentlyrotatethesensor.
4. Walkthroughthecoverage
areanotingwhereyouare
whenthelightsturnon(also,
the LED will ash several
times when motion is de-
tected). Move the sensor
headup,down,orsideways
to change the coverage
area. Keep the sensor at
least 1" (2.5 cm) away from
the lamps.
5. AdjusttheRANGEasneed-
ed.RANGEsettoohighmay
increasefalsetriggering.
6. Secure the sensor head
by tightening the clamp
screw.Donotovertighten
thescrew.
7. Set the amount of TIME you want the lights
tostayonaftermotionisdetected(1,5,or10
minutes).
WARNING: Risk of fire. Do not aim the
lamps at a combustible surface within 3 ft.
(1 m).
Clamp
Screw
Ball Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
Note:Sensorhasa1
1
/
2
minute warm up period
beforeitwilldetectmotion.Whenrstturnedon
wait1
1
/
2
minutes.
2. TurntheRANGEcontroltothemediumposition
(halfwaybetweenMINandMAX)andtheON-
TIMEcontroltotheTESTposition.
 previous next