Heath Zenith 9700LeD Home Safety Product User Manual


  Open as PDF
of 20
 
2
598-1360-00
WIRING THE LIGHT CONTROL
WARNING: Turn power off at circuit breaker
or fuse.
MOUNT THE LIGHT CONTROL
1. Alignthelightcontrolcoverplateandcoverplate
gasket.Securewiththemountingbolt.
2. Alignthethreeslotsinthedecorativeshellwith
thelampholderpins.Pushtheshellinandthen
twistclockwisetolock.Repeatforothershell.
LockNut
Toavoidwaterdamageandelectricalshock,
keeplampholders30°belowhorizontal.
5. Adjustthelampholdersbylooseningthelock
nutsbutdonotrotatethelampholdersmorethan
180°fromthefactorysetting.Whenscrewingin
theoodlamps,donotovertighten.
Keeplampsat
least1"(25mm)
fromthesensor.
Donotallowthe
lampstoblock
thelens.
Lens
3. Pushtherubberplugrmlyintoplace.
4. Ifawetlocationjunctionboxwasnotused,
caulk the wall plate mounting surface with
siliconeweathersealant.
ShellSlot
1. Removetheexistinglightxture.
2. Installthemountingstrapasshownusingtwo
screwsthattyourjunctionbox.
3. Theplastichangercanbeusedtoholdthexture
whilewiring.Thesmallendoftheplastichanger
canbethreadedthroughtheholeinthecenter
ofthecoverplate.Thesmallendthengoesinto
oneoftheslotsonthemountingstrap.
4. Routethelightcontrol’swiresthroughthelarge
gasketholes.
5. Twistthejunctionboxwiresandxturewiresto-
getherasshown.Securewithwireconnectors.
White to WhiteBlack to Black
Junction box ground wire to green ground screw
on fixture.
Gasket
Mounting
Strap
MountingBolt
RubberPlug
 previous next