Heath Zenith 9700LeD Home Safety Product User Manual


  Open as PDF
of 20
 
Dated receipt required for warranty replacement.
FEATURES
• Automaticallycomesonwhenmotionisdetected.
• Automaticallyturnslightoff.
• Photocell keeps the light off during daylight
hours.
• LEDindicatesmotionwassensed(dayornight).
REQUIREMENTS
• Thelightcontrolrequires120voltsAC.
• If you want touse Manual Override mode, the
controlmustbewiredthroughaswitch.
NOTICE:Nottobeusedonlightdimmerortimer-
controlledcircuits.
• Some electrical codes require installation by a
qualified electrician.
• Thisproductisintendedforusewiththeenclosed
gasketandwithajunctionboxmarkedforusein
wetlocations.
• Thislightxturehasbeentested/certiedusing
Lights of America LED Lamp Model Numbers
2003LEDP38-65K, 2002LEDR30-65K, and
2002LEDP30-65K.
UNPACKING
Besuretoremoveallcontentsfrompackagingand
verifyallitemsarepresentbeforeassemblingthislight
xture.Thispackageincludesthefollowingitems:
• SecurityLight
• TwoLEDPAR38lamps
(LightsofAmericaModel:2003LEDP38-65K)
• Twodecorativelampshells
• MountingStrap
• PlasticHanger
• RubberPlug
• Mountinghardware
• Wirenuts
• Owner’sManual
©2008 598-1360-00
Motion Sensor
Light Control
Model: 9700LED Series
INSTALLATION
Foreasyinstallation,selectanexistinglightwitha
wallswitchforreplacement.
Forbestperformance,mountthextureabout8ft.
(2.4m)abovetheground.NOTE:Ifxtureismounted
higherthan8ft.(2.4m),aimingthesensordownwill
reducecoveragedistance.
For eave mount only:
1. Swingthesensorheadtowardstheclampscrew
joint.
For under eave installation, the sensor head must
be rotatedasshowninthenexttwostepsforproper
operationandtoavoidtheriskofelectricalshock.
Controls
Controls
Controls
Eave Mount
Wall Mount
ClampScrew
2. Thenrotatethesensorheadclockwise180°so
thecontrolsfacedown.
Ifthesensorpopsoutoftheballjoint,loosenthe
clampscrewandpushthesensorbackintotheball
joint.Tightentheclampscrewwhendone.
next