Heath Zenith 6270 Series Door User Manual


  Open as PDF
of 28
 
-2-
595-5506-12
12345
678
Jumpers
Chime Volume
SawtoothHanger
Figure 4
5. Mount push button.Useeitherscrewsordouble
sidedtapetomountpushbutton.
• ScrewMounting:Tomountwithscrews,remove
backofcasebypushingintabonbottomwithasmall
screwdriver(seeFigure1).Note: Remove material in
screwholes(ifneeded)beforemountingwithscrews.
Attachbackofcasetodoorjamborwall(seeFigure
3).Snapfrontofpushbuttonon.
• Tape Mounting:Whenattachingpushbuttonusing
double sided tape, make sure the surface of the door
jamborwallisclean.
6. Mount chime.
Determinemountinglocation.
Therearedifferentwaystomountthechimedepending
uponthemodelofchimepurchased.Determinewhich
modelyoupurchasedbelow.Mountthechimeaccording
totheinstructionsforyourchime.
ChimewithAttachedDecorativeCover:
1. Drill1/4"diameterpilotholeforwallanchor(provided)andinsertanchor.
2. Screw#8screw(provided)intoanchor.Leave1/16"gapbetweenscrewhead
andwall.
3. Placehangeroverscrewtomountchime(seeFigure4).
Figure 3
SawtoothHanger
Screw
 previous next