Filter
Top Products
3
Features & Benefits
Cabinet
Minimal height of the low profile series makes it ideal for low ceiling coolers
Cabinet design features front access panels on each side for easy access to electrical and refrigeration components
All electrical components factory wired to terminal board and identified, making it easy to field wire the unit
Sweat connections to reduce potential for leaks
Internal panels are isolated for quiet operation
Liquid line solenoid wire harness is factory-installed for quick installation
Pre-drilled holes on the back of the unit for room thermostat
•
•
•
•
•
•
•
Coil
Internally enhanced tubing and fin design for higher efficiency
Coil heater slots have been enlarged for easier installation and replacement
Reduced heater wattages
Hot gas loop on bottom of coil for easier access is standard for hot gas defrost models
Fixed defrost termination for electric, adjustable defrost termination for hot gas
•
•
•
•
•
Drain Pan
Large diameter drain hole (3/4" ID) is located on the back of the unit
Extended drain pan heaters for more uniform defrost throughout the drain pan and additional heat in
end compartments
On 4-6 fan models, drain pan has a lanyard for easy and safe access
•
•
•
Motors
Motors plug into wiring harness for easier servicing
EC motors available factory-installed or as a drop-in replacement through InterLink™ Commercial Refrigeration Parts in
115/1/60, 208-230/1/60 and 208-230/3/60 unit voltages
PSC and PSC (Totally Enclosed) motors for 115/1/60, 208-230/1/60 and 460/1/60 unit voltages
PSC motors or EC motors required for 50 Hz operation
•
•
•
•
Options
Unit Configurations: mounted components, pre-assembled, pre-charged and Beacon II™
- Units available with mounted TXV and mounted TXV / solenoid valve
- Pre-assembled units come with mounted TXV, liquid line solenoid valve and room thermostat. Available in a master
liquid line configuration
- Pre-charged units come with mounted TXV, liquid line solenoid valve, room thermostat and quick connect fittings
- Various room thermostat variations including rear mount and front access versions
- Beacon II units come with electronic expansion valves, pressure transducer, temperature sensors and Beacon
control board
Units available with stainless steel housing and drain pan
Units available with copper fins. Air defrost units also available with polyester coated fins or various coil coatings options
Units available with insulated drain pan
•
•
•
•