Heat & Glo LifeStyle XLR-PLUS-PB-AU Indoor Fireplace User Manual


 
Heat & Glo • XLR-PLUS-N-AU, XLR-PLUS-PB-AU • 2264-900 Rev. M • 7/12 58
Non-Combustible Finish Material 0 - 1 in. (25 mm) Thick
Bottom Joint
3/4 in.
(19 mm)
3 in.
(76 mm)
3/4 in.
(19 mm)
Figure13.11NoncombustibleSurfaceFinishingMaterial
0-1in.(25mm)Thick-InsideFitMethod
(TonicDecorativeFrontOnly)
FACTORY-INSTALLED
NON-COMBUSTIBLE
BOARD
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
DRYWALL OR
EQUIVALENT
3/8 in. (10 mm)
20-1/2 in. (520 mm)
APPLIANCE OPENING (HEIGHT)
3/4 in.
(19 mm)
3 in. (76 mm)
1 in.
(0-25 mm)
(MAX)
1 in.
(0-25 mm)
Figure13.10InsideFitMethod(TonicDecorativeFrontOnly)
Non-CombustibleFinishMaterials
0mmto1in.(25mm)ThickInsideFitMethod
The Tonic decorative front is approved for inside t ap-
plications. Non-combustible nishing materials up to 1 in.
(25 mm) thick can be installed around the front (left, right,
top, and bottom).
For the Tonic decorative front inside t applications, the
decorative front must be installed tight to the nishing
anges and must not overlap any nish material.
Ensure that no non-combustible nish materials are in-
stalled within 3/4 in. (19 mm) of the top of the replace
opening, or within 3 in. (76 mm) of the bottom of the re-
place opening. The 3/4 in. (19 mm) spacing is required
to provide clearance for removing and installing the Tonic
decorative front. See Figure 13.11.
D. DecorativeFronts
WARNING! Risk of Fire! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
Only doors certied for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used.
TONIC DECORATIVE FRONT
(TN-SLR-**)
Figure13.12TonicDecorativeFront
InsideandOverlapMethod
SeeSection13.C.
MARTINI DECORATIVE FRONT
(MT-SLR-**)
Figure13.13MartiniDecorativeFront
Inside-FitMethodOnly
SeeSection13.C.