Filter
Top Products
Page 30
August 1, 2008
Heat & Glo · Tiara Petite B · 7026-101K
Figure 7.1
Figure 7.2
D. Ignition Module Access and Battery
Replacement
CAUTION
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Black
Black
Ignition Module
Switch
ON/OFF
O
F
F
P
I
L
O
T
O
N
TP
TH
TPTH
LO
HI
EA
P
I
L
O
T
PILOT ASSEMBLY
VALVE
TH
TP
TPTH
Thermopile
Gas Pilot Igniter
Thermocouple
The single "AA" 1.5V battery that powers the ignitor is
located in the module. To replace the battery, open the
battery compartment and remove the old battery. Replace
the battery making sure the polarity is correct.
1. Lift off the appliance top and place it on a fl at surface,
with the porcelain side up to prevent damage.
2. Remove the appliance front by sliding it upwards in the
grooves, being careful not to chip the porcelain. Lay the
front face up on a fl at surface.
3. With the cast iron front removed, remove the decorative
cover located under the apliance. To remove the cover,
remove the two screws on the front of the appliance that
hold the cover in place. Pull the cover forward, down
and out. The module will then be accessible for service
and battery replacement.
The Ignition Module is located under the appliance attached
to the decorative cover.
To access the module:
Shock hazard.
• Replace damaged wire with type 105
O
C
rated wire.
• Wire must have high temperature insulation.
CAUTION
CAUTION
Battery polarity must be correct or module damage will occur.