Filter
Top Products
28
Figure 15. Placement of the Ember Material
GLASS SPECIFICATIONS:
LARGE GLASS: TEMPERED
SMALL GLASS: TEMPERED
• Save the remaining
ember materials for
use during fireplace ser-
vicing. The bag of em-
bers provided is suffi-
cient for 3 to 5 applica-
tions.
• Replace the wing nut,
glass clips and screws.
• Replace the glass door
and a front trim door on
the unit.
• Hand tighten the wing
nut.
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Golden Ember (GE-93) is flame colorant material.
The bag labeled Glowing Ember (050-721) is standard
glowing ember material. To place the ember material:
• Remove the wing nuts and glass clips or tension springs
around the glass door. Remove the glass door from the unit.
• Place dime size pieces of ember material about 1/2
inch apart near port holes in burner top. Do NOT press
embers into burner ports. Cover the top of the burner
with a single layer of ember material. For best perfor-
mance do NOT place embers on the ports at the rear of
the burner.
Heat-N-Glo fireplaces manufactured with tempered
glass may be installed in hazardous locations such as
bathtub enclosures as defined by the CPSC. The tem-
pered glass has been tested and certified to the require-
ments of ANSI Z97.1-1984 and CPSC 16 CFR 1202.
(Safety Glazing Certification Council SGCC # 1595 and
1597. Architectural Testing, Inc. Reports 02-31919.01
and 02-31917.01.)
This statement is in compliance with CPSC 16 CFR
Section 1201.5 “Certification and labeling requirements”
which refers to 15 USC 2063 stating “…Such certifi-
cate shall accompany the product or shall otherwise be
furnished to any distributor or retailer to whom the prod-
uct is delivered.”
Some local building codes require the use of tempered
glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory.
Please contact your dealer or distributor to order.