Filter
Top Products
Heat & Glo • SLR32 • 2269-900 Rev. E • 4/1254
Non-Combustible Finish Material 0-4 Inches Thick
Bottom Joint
3/4 IN.
3/4 IN.
3 IN.
Figure 13.11 Noncombustible Surface Finishing Material 0-4 Inch
Thick-Inside Fit Method (Tonic Decorative Front
Only)
FACTORY-INSTALLED
NON-COMBUSTIBLE
BOARD
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
DRYWALL OR
EQUIVALENT
(1/2 IN.)
0-4 IN.
20-1/2 IN. APPLIANCE
OPENING (HEIGHT)
0- 4 IN.
3/4 IN.
3 IN.
Figure 13.10 Inside Fit Method (Tonic Decorative Front Only)
Non-Combustible Finish Materials
0 Inches to 4 Inches Thick-Inside Fit Method
The Tonic decorative front is approved for inside fi t ap-
plications. Non-combustible fi nishing materials up to 4
inches thick can be installed around the front (left, right,
top, and bottom).
For the Tonic decorative front inside fi t applications, the
decorative front must be installed tight to the fi nishing
fl anges and must not overlap any fi nish material.
Ensure that minimum clearances to non-combustible fi n-
ish materials meet the specifi cations in Figure 13.11.