Heat & Glo LifeStyle EM-485T - 42 Indoor Fireplace User Manual


 
41
Firebox
Repack
Insulation
Knockout
Combustible
Materials
Maintain air clearance
to combustibles.
Gas line
Combustible materials
may be located at zero
clearance to gas line
beyond 4 in. (102 mm)
from fireplace side.
Gas line
1-1/2 in.
(38 mm)
air space
Refractory
Seal with
fireplace mortar
or high temp
non-combustible
sealant
4 in.
(102 mm)
Outer Shell
of Fireplace
Figure 12.1 Gas Line Installation
12
Accessories
A. Gas Log/Lighter Provision
WARNING! Fire and/or Asphyxiation Risk! Use with
solid wood fuel or decorative gas appliance only. Gas re
generates fumes.
DO NOT install unvented gas logs
Damper must be locked fully open when gas logs are
installed
A certied gas log lighter or decorative gas log set can be
installed in this replace.
Maximum input is 100,000 BTU/hr.
Decorative gas appliance must be certied to ANSI
Z21.60 “Standard for Decorative Gas Appliances for
Installation in Vented Fireplaces”.
Must be installed in accordance with the National Fuel
Gas Code, ANSI Z223.1.
A gas log set must incorporate a gas shutoff.
Gas Log set requires the damper to be locked fully
open.
Knockouts are provided on both sides of the replace
and in refractories for 1/2 in. (13 mm) iron pipe.
Seal refractory around pipe with replace mortar or a
high temperature, non-combustible sealant.
B. Wood Burning Inserts
WARNING! Risk of Fire! Improper installation of wood in-
serts may cause replace or chimney system to overheat.
If a wood burning insert is being installed in this replace,
Hearth & Home Technologies recommends full reline of
the chimney.
Cooling air openings at the top of the chimney must not
be obstructed in any manner.
Hearth & Home Technologies recommends securing the
reline at the top of the ue and using the cap certied for
use with this replace system.
C. Install Fan
Optional.
Follow instructions included with fan kit.
WARNING! Risk of Electric Shock! DO NOT remove
grounding prong from plug or route cord under or in
front of appliance. Plug directly into a properly ground-
ed three-prong receptacle and route cord away from
appliance.
Heat & Glo • EM-415, EM-485 • 33056 • Rev AF 7/12