Filter
Top Products
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06
44
B. Lighting Appliance
Intellifire Ignition
LIGHTING
INSTRUCTIONS
TO TURN OFF
GAS TO APPLIANCE
1. Turn off all electric power to the appli-
ance if service is to be performed.
2. Flip both Pilot and Flame ON/OFF
switches to the “OFF” position.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance is equipped with
an electronic pilot ignition de-
vice which automatically lights the
pilot. Do
not try to light the pilot by
hand.
B. BEFORE LIGHTING, smell all
around the appliance area for
gas. Be sure to smell next to the
floor because some gas is
heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
DO NOT CONNECT 110 VAC
TO THE CONTROL VALVE.
Improper installation, adjustment,
alteration, service or maintenance
can cause injury or property dam-
age. Refer to the owner's informa-
tion manual provided with this ap-
pliance.
This appliance needs fresh air for
safe operation and must be in-
stalled so there are provisions for
adequate combustion and ventila-
tion air.
If not installed, operated, and main-
tained in accordance with the
manufacturer's instructions, this
product could expose you to sub-
stances in fuel or fuel combustion
which are known to the State of Cali-
fornia to cause cancer, birth de-
fects, or other reproductive harm.
Keep burner and control compart-
ment clean. See installation and
operating instructions accompany-
ing appliance.
CAUTION:
Hot while in operation. Do not
touch. Keep children, clothing, fur-
niture, gasoline and other liquids
having flammable vapors away.
Do not operate the appliance with
panel(s) removed, cracked or bro-
ken. Replacement of the panel(s)
should be done by a licensed or
qualified service person.
• Do not touch any electric switch;
do not use any phone in your build-
ing.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
C. Do not use this appliance if any
part has been under water. Imme-
diately call a qualified service tech-
nician to inspect the appliance and
to replace any part of the control
system and any gas control which
has been under water.
NOT FOR USE
WITH SOLID FUEL
For use with natural gas and pro-
pane. A conversion kit, as supplied
by the manufacturer, shall be used
to convert this appliance to the al-
ternate fuel.
Also Certified for Installation in a
Bedroom or a Bedsitting Room.
For assistance or additional infor-
mation, consult a qualified installer,
service agency or the gas supplier.
WARNING:
2095-913B
For additional information on operating your Hearth Technologies appliance, please refer to www.Fireplaces.com.
1. Turn off all electric power to the appli-
ance.
2. This appliance is equipped with an elec-
tronic pilot ignition device which auto-
matically lights the pilot. Do
not try to light
the pilot by hand.
3. Wait five (5) minutes to clear out any
gas. Then smell for gas, including near
the floor. If you smell gas, STOP! Fol-
low "B" in the Safety Information located
on the left side of this label. If you don't
smell gas, go to next step.
4. Turn on all electric power to the appliance.
5. Push the Flame ON button.
Note: There will be a 3 minute
delay before the burner will light.
6. If the appliance will not operate, follow
the instructions “To Turn Off Gas to Ap-
pliance” and call your service technician
or gas supplier.
Note: To operate pilot without the
burner, push the pilot button.