Filter
Top Products
The BW36 Series fireplace system has been tested
and listed in accordance with the UL127 Standards,
and has been listed by Underwriters Laboratories Inc.
for installation and operation in the United States as
described in these Installation & Operating
Instructions.
The BW36 Series fireplaces have been tested and
listed for use with the optional components given on
page 4. These optional components may be pur-
chased separately and installed at a later date.
However, installation of an outside air kit will require
significant reconstruction, and should be installed at
the time of the initial fireplace installation.
Check with your local Building Code agency prior to
installing this fireplace to ensure compliance with local
Codes, including the need for permits and follow-up
inspections. If any assistance is required during
installation, please contact your local dealer or the
Heat-N-Glo Technical Services Department, 20802
Kensington Blvd., Lakeville, MN 55044.
Heat-N-Glo is a Division of Hearth Technologies Inc.
WARNING!
THIS HEAT-N-GLO FIREPLACE AND ITS COMPONENTS ARE DESIGNED TO BE
INSTALLED AND OPERATED AS A SYSTEM. ANY ALTERATION TO OR
SUBSTITUTION FOR ITEMS IN THIS SYSTEM, UNLESS ALLOWED BY THESE
INSTALLATION INSTRUCTIONS, WILL VOID THE UNDERWRITERS LABORATORIES
LISTING AND MAY VOID THE PRODUCT WARRANTY. IT MAY ALSO CREATE A
HAZARDOUS INSTALLATION.
READ THROUGH THESE INSTRUCTIONS THOROUGHLY BEFORE STARTING YOUR
INSTALLATION AND FOLLOW THEM CAREFULLY THROUGHOUT YOUR PROJECT!
The HEAT-N-GLO fireplace system consists of the following:
1. Fireplace/Integral Grate 3. Chimney System
2. Hearth Extension 4. Chimney Termination Cap
Optional components include:
1. Glass Doors 3. Heat Circulating Fans
2. Outside Combustion Air System
4-00 3 30491D
BW36 SERIES WOODBURNING FIREPLACE
A. LISTINGS AND CODE APPROVALS
B. DESCRIPTION OF THE FIREPLACE SYSTEM
NOTE: Illustrations throughout these
instructions reflect “typical installations”
and are for design purposes only. Actual
installation may vary slightly due to indi-
vidual design preferences. However, min-
imum and maximum clearances must be
maintained at all times.
The illustrations and diagrams used
throughout these installation instructions
are not drawn to scale.
Tools and Building Supplies Normally
Required:
Tools Building Supplies
Saw Hearth Extension Material
Pliers Wall-finishing Materials
Hammer Framing Material
Phillips Screwdriver Fireplace Surround
Tape Measure Caulking Material
Plumb Line
Level
Electric Drill and Bits
Framing Square
No one builds a better fire