Filter
Top Products
Heat & Glo • 6000GLX-IPI-S/-R, 6000GLX-IPILP-S/-R • 2101-900 Rev. Q • 11/0852
A. Remove Fixed Glass Assembly
See Section 14.H.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
14
14
Appliance Setup
STEP 1.
Place the back piece of refractory in back of the fi rebox.
The small indentation on one side goes down. Lean the
refractory slightly so it doesn’t tip over.
Figure 14.1
Figure 14.2
E. Install the Refractory
Note: The red refractory will naturally darken when the
fi rebox heats up. The red color will return when the fi rebox
cools.
STEP 2.
Place the left side refractory onto the left side of the burner.
Push the back refractory against the back wall. Place the
bumps on the bottom of the left refractory into the grooves
on the burner surface. Push to top gently against the side
of the fi replace. Once in place push it back so the bevel
cuts sit against each other and the seam is minimized.
Figure 14.3
STEP 3.
Repeat step 2 for the right side.