Heat Controller PE-91A PE-121A Air Conditioner User Manual


 
8
Heat Controller, Inc.
1900 Wellworth Avenue
Jackson, MI 49203
SAFETY
7.
Connection to the main electrical supply must comply with local and national
electrical codes.
1. Do not damage the power cord.
2. Never lay this unit down. Operate in upright position only.
3. Be sure that air inlets and outlets are not blocked or covered up.
4. Never place anything on top of the unit.
5. Do not use this product outdoors.
6. Never connect the unit to a defective outlet.
7. Plug the unit into a properly grounded 15 Amp, 115V AC circuit. Check
your breaker box to determine which circuit the outlet is on. A dedicated
circuit is recommended.
8. Make sure that the unit is correctly connected before turning on the unit.
9. Do not use the plug as a disconnecting means.
10. DO NOT USE AN EXTENSION CORD for this unit.
11. Do not use an adapter plug to a two slot outlet unless proper grounding of
the outlet and/or ground wire is verified. Consult an Electrician.
12. Do not bend or crush the air inlet or air outlet hoses.
13. Do not allow children to play near the unit.
14. Do not place the power cord under a carpet.
15. Keep the area around the exhaust port/air inlet and air outlet hoses
sufficiently clean and make sure that it is not congested.
16. For any repairs, refer directly to our Customer Service Department.
Repairs carried out by unqualified people may cause damage or may
even be dangerous and may void the warranty.
DO NOT:
Place objects inside the air outlet or air inlet grid.
Use this unit inside closets or cabinets.
Repair, disassemble and/or modify the unit by yourself.
Use this unit in proximity to inflammable and/or explosive substances.
Operate this unit without filter.
Before cleaning this unit, make sure that it is unplugged. Do not wash the unit
with water, gasoline or solvents of any kind. (See Section 11).
To avoid the risk of shock, the product should never be used in bathrooms,
shower rooms, or in any other steamy or wet areas.
Do not use the unit on a table as the unit is supported by wheels. Place unit on
level floor.