Filter
Top Products
15
Heat Controller, Inc.
1900 Wellworth Avenue
Jackson, MI 49203
OPERATION
9.
9.3 Auto
,
Cool
,
Heat
,
Dr
y,
Fan Mode
Dry Mode:
1. Plug the Power Cord into the power outlet.
2. Turn on the unit by pressing the ON/OFF Button on the Control Panel.
3. Press the Mode Button until the signal “ “ appears on the display.
4. Set the room temperature to your desired room temperature with
temperature change button.
5. Keep the windows and the doors closed to aid the effectiveness.
6. The unit will only operate at low fan speed in Dry Mode. It is
recommended not to install the exhaust hose for the best dehumidifying
effect; however, the room may become too warm for comfort. In this case,
the exhaust hose should be used.
NOTE: The unit will not perform dehumidifying when the room temperature
is lower than 64°F.
Heat Mode:
1. Plug the Power Cord into the power outlet.
2. Turn on the unit by pressing the ON/OFF Button on the Control Panel.
3. Press the Mode Button until signal “ “ appears on the display.
4. Set the room temperature to your desired room temperature with
Temperature Changing Button.
Then set temperature range from 60°F to 82°F.
We recommend temperature for your comfort between 69°F to 75°F.
5. Select the fan speed by pressing the Fan Speed Button. It is
recommended to use a low fan setting.
The Heating Function is provided by an electric heat element. The
compressor will not operate in HEAT Mode. It is not necessary to connect any
of the exhaust hoses to the unit.
Fan Only Mode:
1. Plug the Power Cord into the power outlet.
2. Turn on the unit by pressing the ON/OFF Button on the Control Panel.
3. Press the Mode Button until signal appears on the display.
4. Select the fan speed by pressing the Fan Speed Button.