Filter
Top Products
August 1, 2008
Page 21
Heat & Glo · Tiara I B & Tiara II B · 7010-149M
4. Existing Masonry Chimney
Type C - Up & Out Installation
Type D - Hearth Mount
Figure 5.24
Type A & B Co-Axial to Co-Linear
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear Connector
3 in. (76m
m
Flex Lin
e
Pipe Length
Optional
Showing t
w
30 ft.
(9m)Sectio
n
of Flex Lin
e
Chimney Liner
Termination Cap
Co-Axial to Co-Linear
Connector
30 ft. (9m) of 3 in.
(76mm) Flex Liner
Exhaust Section
Pipe Length
Optional
4 ft. (1m) of 3 in. (76mm)
Flex Liner Air Intake Section
The chimney must be
sealed from the 4 ft. (1m)
section to termination
using a smoke shelf or a
damper*. The seal
should be 6 in. (152mm)
below the end of the 4 ft.
(1m) Air Intake section.
This section of the
chimney must be
sealed
TERMINATION
CAP
FLASHING
4 in. (102mm)
FLEX LINER
TOP ADAPTOR
RETRO
CONNECTOR
90° ELBOW
DIRECT
VENT PIPE
Chimney Liner
Termination Cap
30 ft. (9m) of 3 in. (76mm)
Flex Liner Exhaust Section
4 ft. (1m) of 3 in.
(76mm) Flex Liner
Air Intake Section
Chimney must be sealed
from 4 ft. (1m) section to
termination using a smoke
shelf or a damper*. Seal
should be 6 in. (152mm)
below end of 4 ft. (1m) Air
Intake section.
This section of the
chimney must be sealed
Co-Axial to Co-Linear Connector
Alcove Clearance to
Combustibles must be
maintained
*NOTE: In the Commonwealth of Massachusettes, the word damper shall
be replaced with the words fl ue restrictor.
*NOTE: In the Commonwealth of Massachusetts, the word damper shall
be replaced with the words fl ue restrictor.