Filter
Top Products
Heat & Glo • Escape-42DV • 2052-900 Rev. R • 10/0822
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at least 1-1/2
inches.
• Use pilot holes for screws.
• Screws must not exceed one inch long.
• Pipe may separate if not properly joined.
A. Assembly of Vent Sections
8
8
Installing Vent Pipe
Assembling Pipe Sections
Insert the inner fl ue of section A into the fl ared inner fl ue of
section B.
Start the outer fl ue of section A over the outer fl ue of section B
(see Figure 8.2). Note: The end of the pipe sections with the
lances/tabs on it will face towards the appliance.
Once both inner and outer fl ues are started, press section A
onto section B fi rmly until all lances have snapped into place.
Check to make sure they have snapped together (see Figure
8.3) and the seams are not aligned (see Figure 8.4). Tug
slightly on section A to confi rm it has completely locked into
place. It is acceptable to use screws no longer than 1 inch to
hold outer pipe sections together. If predrilling holes, do NOT
penetrate inner pipe.
For 90° and 45° elbows that are changing the vent direction
from horizontal to vertical, one screw minimum should be put in
the outer fl ue at the horizontal elbow joint to prevent the elbow
from rotating. Use screws no longer than 1 inch. If predrilling
screw holes, do NOT penetrate inner pipe.
Attaching Vent to the Firebox Assembly
To attach the fi rst pipe section to the collars, slide the male
end of the inner vent of the pipe section over the inner collar
on the fi rebox assembly. At the same time, slide the outer fl ue
over the outer collar on the appliance. Push the pipe section
into the appliance collar until all the lances (see Figure 8.1)
have snapped in place. Tug slightly on the section to confi rm
it has completely locked into place.
Figure 8.1 Lances
Figure 8.2
A
B
Figure 8.3
WARNING
Commercial, Multi-family (Multi-level exceeding two
stories), & High-Rise Applications
For Installation into Commercial, multi-family (multi-level ex-
ceeding two stories) or high-rise applications: All pipe joints
must be sealed with high temperature silicone, including the
slip section that connects directly to the horizontal termina-
tion cap.
• Apply a bead of silicone sealant inside the female outer
pipe joint prior to joining sections. See Figure 8.1
• Only outer pipes are sealed. Do not seal the inner fl ue.
All unit collar, pipe, slip section, elbow and cap outer fl ues
shall be sealed in this manner, unless otherwise stated.
Fire Risk
Explosion Risk
If slip section seals are broken during the
removal of the termination cap, gas will leak and
a fi re or explosion may occur.
Do not break silicone seals on slip sections.
WARNING
Note: The end of the pipe sections with the lances/tabs on
it will face toward the appliance.
High Temperature Silicone Sealant
Commercial, Multi-family (multi-level exceeding two
stories), or High-rise Applications only
Do not mix pipe, fi ttings or joining
methods from different manufacturers.
WARNING