Filter
Top Products
Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/0840
Figure 9.16 Cover Plate-Replace
Figure 9.17 Place Cover Plate on Top of Appliance
• Locate heat shield cover plate removed in the fi rst step.
Place the heat shield cover plate on top of heat shield.
Replace four screws to hold this plate in place. See
Figure 9.16.
• Locate outer shell cover removed in the sixth step
(Figure 9.7). Place the cover on top of appliance. See
Figure 9.17. Replace four screws to hold plate in place.
See Figure 9.18.
Figure 9.18 Screw Cover into Place
Figure 9.19 Completed Conversion
• The appliance should look like the one shown in
Figure 9.19 after it has been converted to a rear vent
appliance.