Hearth and Home Technologies 8300 Indoor Fireplace User Manual


 
HearthStone Quality Home Heating Products Inc Champlain Model #8300
3
INTRODUCTION
Congratulations on your purchase of a
Champlain Gas-Fired Direct Vent heater.
The Champlain, by HearthStone Cast Iron
Stoves, incorporates the latest in balanced
vent gas technology, which will provide you
with clean, efficient heat for years to come.
The Champlain will provide you with years
of practical and convenient service.
However, as with any gas appliance, the unit
must be properly and safely installed and
maintained by qualified service personnel to
ensure safe and trouble-free operation.
Your Champlain is equipped with a standard
pilot which:
1. generates a milli-volt signal that
powers the wall-mounted thermostat
and;
2. lights the main burner when the
thermostat calls for heat.
This unit is equipped with an
On/Off/Thermostat switch and a variable
output control. The variable output control is
located on the gas control valve. It allows
you to vary the heat output, along with the
flame height to suit personal taste. Heat
output can be reduced {set to “LOW”}
during the Fall and Spring, when the need
for heat is reduced and increased {set to
“HIGH” during Winter months, when the
need for heat is the greatest.
A wall-mounted thermostat is provided by
HearthStone. Regardless of how you set the
variable output control, when the optional
thermostat has been installed and the
On/Off/Thermostat switch is set to
“Thermostat”, the wall-mounted thermostat
will control the on/off cycling of the unit. At
any time, you can override the thermostat
with the On/Off/Thermostat switch by
setting it to “ON” or “OFF”.
The Unit can also be equipped with an
optional blower fan, which turns on and off
independently of the burner flames. When
the speed switch, which allows you to turn
the fan on or off and control the speed of the
fan to suit your needs, is set to “On”, the fan
will automatically turn on when the stove is
hot and cycle off when the unit is no longer
hot.
Also available are two different optional
remote controls. Both of the remote controls
are capable of turning the unit on and off.
One of the optional remotes also allows you
to control the temperature of the stove from
anywhere in the vicinity of the unit. If “ON”
& “OFF” are the only controls required, Kit
# 90-56912 can be used. If you would like to
control the temperature via the remote
control, use Kit # 90-56914.
READ THIS OWNERS MANUAL
Operate and maintain this gas heater
according to the instructions in this manual.
Read this manual in its entirety. This
manual has two sections, the first section is
for the OPERATOR, and the second section is
for the QUALIFIED SERVICE PERSONNEL only.
HEATER MUST BE INSTALLED
AND MAINTAINED BY QUALIFIED
SERVICE PERSONNEL
Verify the gas connections and venting
systems with requirements of local, regional
or national installation codes. Qualified
service personnel must inspect the gas heater
before use and at least annually.
TABLE OF CONTENTS
READ THIS OWNER’S MANUAL........ 1