Filter
Top Products
Heat & Glo • 6000GBV, 6000GBV-IPI • 2104-900 Rev. H • 11/0834
F. Install the Log Assembly
STEP 2.
Place the metal grate on top of the burner.
Position the legs of the grate into the forward set
of indentations in the burner top. Make sure the
grate is all the way forward. See Figure 14.3.
STEP 1.
CAUTION: Logs are fragile! Carefully remove
the logs, grate and supporting cardboard from
the inside of the fi replace See Figure 14.2.
If the gas logs have been factory installed they
should not need to be positioned. If the logs have
been packaged separately, refer to the following
instructions.
Figure 14.3
Figure 14.5 Top View
2103-910
1
1
2
2
3
3
4
4
5
5
STEP 3.
Log #1 (SRV2103-107):
Place the log on the burner so the cutout in the
log goes around the hump in the burner. The outer
legs of the log should self center on the sides of
the burner. The ramp shape in the bottom of the
log sits fully against the ramp shape molded into
the burner. Pull the log forward. The right side of
log will touch the smaller hump. There will be a
1/4 inch or so gap around the hump. See Figures
14.4 and 14.5.
1
1
Figure 14.2
1
1
Figure 14.4 Front View
HUMP
HUMP
SMALLER
SMALLER
HUMP
HUMP
INDENTATIONS
INDENTATIONS
Log Assembly: LOGS-6000G