Filter
Top Products
P38+ Pellet Stove
4
Assembly and Installation
Rear Cover
Panels
Unpacking
Cut straps holding box together and remove box from
skid.
The 38+ is bolted to the skid to prevent movement dur-
ing shipping.
To free the stove from the skid you must remove the
hold-down bolts in the rear of the pedestal base.
Installing Rear Cover Panels
The rear cover panels are removed from the stove to
make it easier to get at the hold-down bolts.
The rear cover panels are packed inside the hopper
and should be installed on the stove as shown. This should be
done after the stove is in place and flue is connected.
Firebrick
Install the firebrick horizontally on the angle above the
burnpot.
Flame Guide
Install the cast iron flame guide on top of the burnpot
and make sure it is fully seated against the auger opening.
The bottom of the flame guide is marked 38+.