Harman Stove Company P43 Stove User Manual


  Open as PDF
of 32
 
25
P43 Pellet Stove
P43 Maintenance - Cleaning the Feeder Body
Pelletneswillaccumulateinthefeederbodyover
a period of time; therefore, a yearly inspection and
cleaning of this area must be performed.
Tocleanoutnes:
1. Remove the rear cover panels.
2. Remove wing nut and feeder cover on the
side of the feeder.
3.Useavacuumcleanertoremoveallnes.
4. Reinstall feed cover, wing nut, and rear
cover panels.
Fig. 39
Pellet Fines will build up in this area
5/16" Hex Head
Screws (2 on
each side)
5/16" Hex Head
Screws (2 on
each side)
The low draft sensor monitors air pressure in the
hopper. Failure to close the hopper lid will result in the
feed motor not running. Depending on the amount of
nesinthefuelbeingburned,thistting,knownas
themufer,mayneedtobecleaned.
Note the location of the mufer and use special
care when cleaning or emptying the hopper.
 previous next