Filter
Top Products
Exception TL200 Wood Stove
13
Door Assembly/Installation Tips
Door Glass
•
Be sure that the door glass is installed in the door with
the label, located on the glass, on the external side of the
door.
•
Rope the glass carefully to insure proper sealing.
•
Apply the rope exactly along the edge of the external
face of the glass, not overhanging or pressed too far in
from the edge.
•
Make sharp 90
o
turns at the corners.
•
Overlap the ends of the rope at the upper left or right
corners.
Glass Retainer Clips
•
Use the glass retainer clips and screws supplied in the
door kit.
•
Use a 1/8" Allen wrench to tighten the glass clips to
cast door with 10-24 x 3/8" screws supplied.
BRASS HANDLE
HANDLE
BOLT
WOOD
HANDLE
SET
SCREW
4 GLASS
RETAINER
CLIPS
4 GLASS
RETAINER
BOLTS
GLASS
GLASS GASKET
DOOR
HINGE PINS
PAW BOLT
•
The paw bolt should be turned into the door from the
inside approximately 14 turns.
•
With the set screw removed, turn the brass elbow onto
the paw bolt approximately 5 turns, or until a 1/16"
clearance is achieved between the elbow and the door
face (make sure to stop on the flat spot of the paw bolt).
•
The set screw on the brass elbow must be aligned to
contact the flat spot on the paw bolt, then tighten using a
5/32" Allen wrench.
•
After attaching the door handle, close and latch the
door by turning the handle to the six o'clock position.
During this process observe to see that the door rope is
being compressed properly.
•
If it does not compress, loosen the set screw and turn
the paw bolt one additional turn into the door. Repeat as
required to ensure a tight seal.
Paw Bolt