Harman Stove Company HB 38 DV Indoor Fireplace User Manual


 
34
INSTALLATION (Options)
Only For Qualified Installers
Speed Control
Knob
Blower Assembly Ready to Install.
Blower Assembly Installed.
Under Floor View
6. Place the blower assembly into the blower box.
You may need to tilt the assembly to get it
through the opening in the blower box. Make
sure the wires do not get pinched.
7. Install finished flooring, carpet, tile, etc.
8. Install register by sliding it down into the
opening. Make sure the speed control door is
over the speed control. The register is designed
to allow for a variation in floor thickness.
9. Turn on electrical power and test.
Operation:
Note: A temperature switch on the fireplace will
not allow the register blower to start if the
fireplace is not warm enough to blow hot air.
This same switch will turn the blower off, if
the fireplace is turned off and cools.
1. Open the speed control door and turn the blower
on to the desired speed. Turning the blower on,
opens the damper in the top of the fireplace and
allows hot air to flow.
2. Close the speed control door.