Filter
Top Products
Page 7For technical questions, please call 1-800-444-3353.Item 69039
3. Assemble a roof side rail using a 3-Way Side Connector B (5-3), then three Rails (3) with
4-Way Side Connectors (6-2) between them, and then a 3-Way Side Connector A (5-2) on the far end.
The Rails connect to the straight ends of the Connectors,
and the curved ends of all Connectors must face up angled the same direction, as shown.
If that is not the case, incorrect connectors were used, or they were assembled backwards.
Figure E: Roof Side Rail Assembly
5-3
6-2
6-2
5-2
3
3
3
4. Assemble a second identical roof side rail by repeating the instructions in step #3.
5. Connect the roof side rail assemblies to the ends of the Rafters (2), as shown below.
6-2
2
2
2
2
5-2
6-2
5-3
3
6-2
5-2
6-2
5-3
3
3
3
Figure F: Roof Side Rail Installation
6. Make sure all parts assembled up to this point are firmly joined together.
Tap parts together gently with a rubber mallet (sold separately) if needed.
Stud, Foot, and Leg Assembly
1. Assemble a Foot (9) to the bottom of each Center Stud (1-1):
a.
9
1-1
Place a Foot (9) onto the bottom
of the Center Stud (1-1).
b.
1-1
15
9
16
Align the holes and insert a
Pin (15) through them.
c.
1-1
15
16
9
Insert a Cotter Pin (16) through
the Pin, and spread end open.
2. Assemble a Corner Leg (23) to the bottom
of each Corner Stud (1-2) as shown.
Figure G: Corner Leg
Assembly
1-2
23
SAFETYMAINTENANCE ASSEMBLY