Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. Item 69039
Roof Cover (18) Installation
Note: Door and Back Covers (19, 20) not shown on illustrations to provide a clear view of installation.
1. Lay the Roof Cover (18) on the ground next to the frame. Make sure that the edges with black straps are
alongside the Door/Back Covers (19,20) and one set of the fabric tubes is facing upwards, see Figure R.
2. Tie each Rope (21) through an eyelet at the corner of the Roof Cover.
3. Throw the other ends of the Ropes (21) over the frame.
4. Move to the other side of the frame and pull the Cover over the frame. Make sure that the Roof
Cover is centred on the frame. If small adjustment is needed, two people should pull together from
the same end of the Portable Garage so that the Roof Cover does not become twisted.
21
18
21 fabric
tube
Figure R: Pull Roof Cover (18) Over Frame using Ropes (21)
5. Insert the Bottom Rails into the fabric tubes on each side of the Roof Cover.
Make sure the Bottom Rails are level and horizontal.
Figure S: Insert Bottom Rails (4)
21
4
4
6. Attach the Bottom Rails (4) to the Corner Studs (1-2) using 3-Way Rail Clamps (8), Bolts, Nuts and
Washers (11, 12, 13), and to the Center Studs (1-1) with 4-Way Rail Clamps (7), as shown in Figure T.
Note: Only finger tighten
the Nuts (12) at this point.
Figure T: 3 and 4-Way Rail Clamp (7, 8) Connections
11
8
13
12
11
13
7
12
7. Make sure that all the bottom cross rails are of the same height from the ground, then tighten all Nuts (12).
8. Secure the four corners to the Corner Legs (23) using Ratchet Tie-downs (22),
see Securing Ratchet Tie-downs (22) on page 10.
SAFETY
MAINTENANCE
ASSEMBLY