Filter
Top Products
SKU 66163 For technical questions, please call 1-800-444-3353. Page 5
SPECIFICATIONS
Power Source 12 VDC
Plug Type 12 VDC Cigaretter Lighter Plug
Fuse Equipped
No. Must be connected to a fused 12 volt
circuit.
Features
Wet & Dry Hand-Held Vacuum.
Detachable Container with Filter for
Convenient Cleaning.
Accessories
Liquid Pick-Up Nozzle (Qty. 1)
Small Crevise Nozzle (Qty. 1)
Large Crevise Nozzle (Qty. 1)
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch (5) of
the Auto Vacuum to its “OFF”
position and unplug the tool
from the vehicle’s cigarette
lighter outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
To pick up 1. solids, attach either the
Long Nozzle (6) or the short Nozzle
(10) to the Collector (2) as follows: a)
To attach the sort Nozzle (1), push
the short end of the Nozzle into the
opening at the front end of the Col-
-
tor angle is in the same orientation
as the tip of the Collector. Push the
Nozzle in until snug. b) To attach the
long Nozzle (6), slide it over the end
of the short nozzle, again keeping
in mind the orientation of the Nozzle
opening with the angle of the Collec-
tor opening.
To pick up 2. liquids, insert the Liquid
Pick-Up Nozzle (7) into the opening
at the end of the Collector (2). IM-
PORTANT: Make sure that the liquid
vacuumed does not rise above the
“MAX” mark on the Collector.
(See Figure A.)
To power the Auto Vacuum, insert the 3.
tool’s 12 Volt Power Plug (11) into a
-
cessories outlet.
IMPORTANT: In certain vehicles,
you may have to switch the ignition to
the accessory mode before the Vacu-
um will operate. (See Figure A.)
Press and hold the Power Switch 4.
(5) to run the Auto Vacuum. While
running, the Power-On Light (4) will
illuminate. (See Figure A.)