Filter
Top Products
SKU 65322 or 65323 For technical questions, please call 1-800-444-3353. Page 13
TECHNICAL
SPECIFICATIONS
Engine Type
6.5 HP, OHV, 4 Stroke,
Gas Engine
Bore x Stroke 68 x 54 mm
Starter Type Manual Recoil Pull Type
Ignition Electronic Ignition
Displacement 196cc
Cooling System Air Cooled
Low Oil Shutdown Yes
Inlet/Outlet Pipe
Outside Diameter
2.5” (Inlet)/3” (Outlet)
Driveshaft Type
Horizontal 3/4” straight.
3/16” Keyed Shaft with
Ball Bearings
Driveshaft Rotation
Counterclockwise (facing
shaft). Length: 2-¼”.
Central Thread: 5/16”-24
TPI
Fuel
Type
91+ octane unleaded
gasoline
Capacity 0.95 Gallons (3.6 Liters)
Engine Oil
Type
SAE 10W30 above 32° F
SAE 5W30 at 32° F or
below
Capacity .5 Quarts (0.5 liters)
Spark Plug
Type
BP6ES, BPR6ES (NGK),
or NHSPLD F6RTCU
Gap 0.7 - 0.8 mm gap
Valve
Clearance
Intake
Cold Engine: 0.15+/-
0.02mm
Exhaust
Cold Engine: 0.20+/-
0.02mm
Distributor
Timing
Opening
Closing
Intake: BTDC 10°
Exhaust: ABDC 20°
Speed
Idle 1700 ± 150 RPM
Maximum 3600 RPM
The emission control system for
this engine is warranted for standards
set by the U.S. Environmental Protec-
tion Agency. For warranty information,
refer to the last pages of this manual.
SERVICING
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
STARTING:
Turn the Power Switch of the
equipment to its “OFF”
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT
SERIOUS INJURY
FROM EQUIPMENT FAILURE:
Do not use damaged
equipment. If abnormal noise,
vibration, or excess smoking
occurs, have the problem
corrected before further use.
Maintenance Procedures
Many maintenance procedures,
including those not detailed
in this manual, will need to
be performed by a qualied
technician for safety. If you
have any doubts about your
ability to safely service the
equipment or engine, have a
qualied technician service the
equipment instead.
Note: Warranty is void if proper mainte-
nance and servicing procedures are
not followed.
Engine Oil Change
CAUTION! Oil is very hot during opera-
tion and can cause burns. Wait for
engine to cool before changing oil.