Filter
Top Products
Page 7SKU 03914
13. Mount the Power Switch under the table top, on the operator’s side. Use the supplied
hardware.
Power Switch
Mounting the Thread Stand
Note: The Thread Stand is designed to be mounted on the Table Stand Kit
(Model 03929-not included). Unless indicated otherwise, all parts referred
to in this set of instructions are listed in the
Bobbin Winder & Thread Stand
Unit Parts List
found on page 28. During assembly, it will be helpful to
refer to that list and the diagram that follows it on page 29.
14. Locate the large hole in the far right corner (from the location that the operator will be
seated) of the Table (not included). Place the Rubber Washer (45) and Washer (37) onto
the Lower Spool Rest Rod (36) and insert the Rod into the hole mentioned above. Place
another Washer (37) over the end of the Rod, and thread on and tighten a Nut (38).
15. Place the Spool Support (46) over the Lower Spool Rest Rod (36) about halfway down.
Insert a Screw (31) and Nut (47) through the Support.
Note: The Support has tabs that hold onto the corners of the Nut to make tightening
easier. When assembling, place the Nut on the side with these tabs.
Tighten the Screw.
16. Insert the threaded end of the Spool Pin (40) through one of the holes in the top of the
arm of the Spool Support (46). Place a Washer (32) and Nut (35) over the end of the Pin
and tighten. Place the Spool Rest (41), Spool Mat (42), and the Spool Vibration Stopper
(39) over the end of the Spool Pin. Repeat this step for both of the Spool Pins (40).
17. Place the Column Pipe Connector (33) over the top of the Lower Spool Rest Rod (36)
until the Rod is about halfway through the Connector. Place a Screw (34) and Nut (35)
through the bottom hole in the Connector and finger-tighten.
18. Place the Upper Spool Rest Rod (30) into the top of the Column Pipe Connector (33).
Place a Screw (34) and Nut (35) through the top hole in the Connector. Tighten all of the
Screws and Nuts in the Connector.
19. Place the Thread Hanger (28) about halfway over the top of the Upper Spool Rest Rod
(30). Insert a Screw (31) and Nut (47) through the Hanger as explained in the note in
step 14, above. Tighten the Screw and place the Column Cap (29) over the end of the
Upper Spool Rest Rod (30).
REV 03/04