Filter
Top Products
22 U32-5 FPI Direct Vent Gas Insert
HAMPTON
®
CAST
FACEPLATE INSTALLATION
1) Lay the faceplate panels fl at, face down on something soft so they
don't scratch.
2) Attach the side fi ller brackets to the left and right sides using 3 screws
and washer per side.
3) Attach the right and left cast sides to the top using 2 screws per
side.
5) Connect the ON/OFF switch wires by taking the black and red wires
with the blue female ends thru the hole provided and connecting
them to the ON/OFF switch.
Ensure that the
top and sides are
aligned.
4) Use a measuring tape to ensure that the distance between the left
and right side pieces is 28" (711mm).
Switch Box Assembly
Boss on rear left side piece.
8) Place the switch box assembly over the boss on the rear left side
piece and secure with one screw.
28"
9) Tuck the wires into the faceplate to keep them away from the insert
using the clip provided. Attach the clip to the rear of the faceplate to
ensure that the wires do not touch the side of the unit.
NOTE: There are fi ller brackets specifi cally for each side. The way
to differentiate this is that on the side of the brackets there are 2
mounting holes. The side where there is a 7/16" gap from the top
of the bracket to the mounting hole, must face the top.
6) Connect the fan switch wires by taking the black and red wires with the
male ends (in the grey harness) thru the hole provided and connect
them with the wire connectors from the fan speed control.
7) Insert wires into the strain relief and install into switch box
assembly.
10) The power cord should be run behind the faceplate panel.
INSTALLATION