Filter
Top Products
14
4.6 Using of the “SPECIAL” Features & Remarks (Continued)
When the unit is under defrost status, it will show “H1” on the
display indicator board . Even if turn off the unit by remote
controller, the unit will not stop defrosting until it is finished;
If change any setting mode by remote controller, the new
functions which is set last time, won't be carried out until
defrosting process is finished.
How it works?
H1 “DEFROSTING”
Operation
How it works?
“SWING”
Operation
About swing up and down
1. Press swing up and down button continuously more than 2s,
the main unit will swing back and forth from up to down, and
then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
2. Under swing up and down mode, when the status is
switched from off to , if press this button again 2s later,
status will switch to off status directly; if press this button
again within 2s,the change of swing status will depend on
the circulation sequence stated below:
About switch between Fahrenheit and Centigrade.
Under status of unit off, press “MODE” and “-” buttons
simultaneously and release both button immediately will switch
in °C and °F.
How it works?
“ °F ” / “ °C ”
Operation
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after
three minutes.
How it works?
Power Failure
During Operation
(Heat Pump Model)
OFF
4. OPERATION OF WIRELESS REMOTE CONTROL UNIT
Operation and Maintenance