Filter
Top Products
5
Lid for right
piping
Lid for under piping pipe
Fix with adhesive tape
Lid for left piping
Heat insulation
material
Drain hose
Piping
Pipe supporting
plate
Indoor/outdoor electric cable
Hooks
mounting plate
mounting plate
Indoor Unit
1
Fitting of the Mounting Plate and Positioning of the Wall Hole
1. Find a suitable mounting location, ensuring there is adequate support to hold
the weight of the unit, check it is level, then temporarily fasten the plate.
2. Check the plate is level, by hanging a thread with a weight from
the central top of the plate or using a spirit level, then fasten securely.
3. Determine the wall hole location ‘A’ using a measuring tape.
Fix a mounting bar to the side bar and lintel (sold separately), and then fasten
the plate to the
mounting bar.
Refertonote1,“ Whenthe mounting plate is “,for thepositionofwall hole.
1. Insert the drain hose into the cavity of heat insulation materials of indoor unit.
2. Insert the indoor/outdoor electric cable from the back of the indoor unit, and
pull it out on the front side, then connect them.
3. Coat the
seal face with refrigerant oil and connect pipes. Cover the
connection part with heat insulation materials, and
it with adhesive tape.
Indoor/outdoor electric cable and drain hose must be bound with refrigerant
piping by protecting tape.
[ Other direction piping ]
Cut away, with a nibbler, the lid for piping (according to the piping direction)
and then bend the pipe according to the position of wall hole. When
bending, be careful not to crush the pipes.
Connect the indoor/outdoor electric cable.
Fixing the indoor unit body
Hang the unit body onto the upper notches of the
mounting plate. Move the body from side to side to
it is securely.
In order to the body onto the mounting plate,hold
up the body on an angle from the underside and
then pull it down perpendicularly.
Unloading of indoor unit body
When you remove the indoor unit,
use your hand to raise the
body from the hooks, then lift the
bottom of the body outward
slightly and lift the unit on an angle
until it separates from the mounting plate.
Indoor side
Outdoor side
ØBmm
Wall hole
Thickness of wall
(Section of wall hole)
Piping hole pipe
G
2
Making a Hole on the Wall and Fitting the Piping Hole Cover
3
Installation of the Indoor Unit
Make a hole of ‘B’mm in diameter, slightly descending to outside the wall.
Install piping hole cover and seal it off with putty after installation.
Drawing of pipe
[ Rear piping ]
Draw pipes and the drain hose, then fasten them with adhesive tape
[ Left Left-rear piping ]
In case of left side piping, cut away, with a nibbler, the lid for left piping.
In case of left-rear piping, bend the pipes according to the piping direction to the
mark of hole for left-rear piping which is marked on heat insulation materials.
HSU-35HEK03/R2(DB)/I
HSU-26HEK03/R2(DB)/I
HSU-53HEK03/R2(DB)/I
HSU-71HEK03/R2(DB)/I
260
260
860
320
1156
70
70 40
105
12
12
138
1046
667191
268
268
299
70
135
85
13
70
13
938
229
245
480
245
562
20
6060 100
110
20