Filter
Top Products
34
General information on laser devices
Your system is a CLASS 1 LASER PRODUCT. This means that the laser is designed in such a way as to
ensure that the maximum permissible emission value cannot be exceeded under any circumstances.
Caution:
If operating devices or methods other than those specified here are employed, it may lead to
dangerous exposure to emissions.
This device emits laser radiation. Because of the danger of eye injuries, the unit may only be opened
or serviced by trained personnel.
If settings other than those specified here are employed or other procedures are carried out, this may
lead to dangerous radiation exposure.
Troubleshooting
Not every kind of sound interference is caused by a defect in your hi-fi system. Defects can also be
caused by leads having been accidentally pulled out, damaged CDs and worn out batteries in the
remote control. If the following measures do not do not rectify the problem, consult an authorised
dealer.
INFORMATION
_____________________________________
CLASS 1
LASER PRODUCT
Fault
No sound.
The hi-fi system does not react when
the buttons are pressed.
The remote control does not work.
Poor radio reception.
Tracks on a CD are skipped.
CD-Rs or CD-RWs are not played
back, or are played back incorrectly.
Possible cause/remedy
The volume setting is too low – increase the volume.
The headphones are plugged in – disconnect the head-
phones.
The power cord is incorrectly connected. Connect it
properly.
Mute is activated, deactivate Mute.
Static electrical discharge. Switch off the hi-fi system, dis-
connect the power cable and plug it in again after a few
seconds or press »RESET«.
The batteries are flat. Replace the batteries.
The remote control is out of range of the stereo.
Weak antenna signal, check the antenna.
Weak FM-stereo signal, switch to Mono.
Interference from electrical devices such as televisions,
video recorders, computers, neon lamps, thermostats or
motors. Keep the hi-fi system away from such devices.
The CD is damaged or dirty – replace the CD or clean it.
The PROGRAM (track memory) or RANDOM functions are
active. Deactivate the functions.
Faulty software or hardware settings during burning or the
CD itself.
Check the components of your CD burner/software or
change the CD being used.
02_CDS_6580_ SPCD.ENG 28.09.2005 15:11 Uhr Seite 34