Filter
Top Products
G0631 79" x 28" Downdraft Table
-13-
Assembly
Components and Hardware Needed: Qty
Filters 16" x 25
" x 1" .......................................... 2
Filters 16
" x 25" x 2" .......................................... 2
Downdraft Plates .............................................
10
Center Downdraft Plate .....................................
1
Pins ................................................................... 8
Left Center Panel ..............................................
1
Right Center Panel ............................................
1
Left Panel ..........................................................
1
Right Panel ........................................................
1
Handles ............................................................. 2
Phillips Head Screws
1
⁄4"-20 x
5
⁄8" ...................... 2
To assemble the downdraft downdraft table:
1. Install the 2" thick filters in the filter bay on
both sides of the downdraft table cabinet as
shown in
Figure 5, then install the 1" thick
filters in front of them.
Note: Be sure to remove the plastic wrap-
ping from the filters before installing. Also,
to ensure that the filters function correctly,
orient the filters so the metal webbing points
toward the impeller
.
Figure 5. Filters installed in filter bay (one side
shown).
1" Filter
2" Filter
Airflow
2. Install the downdraft plates as shown in
Figure 6, placing the thinner center down-
draft plate in the middle.
Figure 6. Installing downdraft plates.
3. Align the right and left center panels with the
rear downdraft table hinges, and secure with
four pins as shown in
Figure 7.
Figure 7. Center panels installed.
Pin
Hinge
4. Fasten the center panels in the middle with
the latches.
Figure 8. Center panels secured with latches.
Latches
Right
Panel
Left
Panel
Left
Panel
Right
Panel
Center
Downdraft
Plate
Rear of
Filter