Graco Series A Heat Pump User Manual


 
308-739 3
WARNING
INJECTION HAZARD
Spray
from the gun, hose leaks, or ruptured components can inject fluid into your body and cause
extremely serious injury
, including the need for amputation. Fluid splashed in the eyes or on the skin
can also cause serious injury
.
D
Fluid injected into the skin might look like just a cut, but it is a serious injury
.
Get immediate medi
-
cal attention.
D
Do not point the gun at anyone or at any part of the body
.
D
Do not put your hand or fingers over the spray tip.
D
Do not stop or deflect leaks with your hand, body
, glove or rag.
D
Do not “blow back” fluid; this is not an air spray system.
D
Always have the tip guard and the trigger guard on the gun when spraying.
D
Check the gun dif
fuser operation weekly
. Refer to the gun manual.
D
Be sure the gun trigger safety operates before spraying.
D
Lock the gun trigger safety when you stop spraying.
D
Follow the
Pressure Relief Procedure
on page 8 whenever you: are instructed to relieve pres
-
sure; stop spraying; clean, check, or service the equipment; and install or clean the spray tip.
D T
ighten all fluid connections before operating the equipment.
D
Check the hoses, tubes, and couplings daily
. Replace worn, damaged, or loose parts immediately
.
Permanently coupled hoses cannot be repaired; replace the entire hose.
D
Use only Graco approved hoses. Do not remove any spring guard that is used to help protect the
hose from rupture caused by kinks or bends near the couplings.
MOVING
P
ARTS HAZARD
Moving
parts, such as the air motor piston, can pinch or amputate your fingers.
D
Keep clear of all moving parts when starting or operating the pump.
D
Before servicing the equipment, follow the
Pressure Relief Procedure
on page 8 to prevent the
equipment from starting unexpectedly
.