Filter
Top Products
2 307906
Table of Contents
W arnings 2......................................
Installation 5.....................................
Operation 8.....................................
T roubleshooting 9................................
Service 10......................................
Parts List 12.....................................
Parts Drawing 13.................................
Dimensional Drawing 14..........................
Technical Data 14................................
Performance Curves 15...........................
Graco Standard Warranty 16......................
Graco I nformation 16.............................
Symbols
Warning Symbol
WARNING
This symbol alerts you to the pos sibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the pos sibility of damage to
or destruction of equipment if you do not follow the
instructions.
EQUIPMENT MISUSE HAZARD
Equipment misu se c an cause the equipm ent to r upture or m alfunction and result in serious injury.
D This equipment is f or professional use only.
D Read all instruction manuals, tags, and labels before y ou operate the equipm ent.
D Use t he equipment only for its intended purpose. If you are not sure, call your Graco distributor.
D Do not alter or modify this equipment. Use only genuine Graco par ts and accessories.
D Check equipm ent daily. Repair or replace worn or dam aged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated component in your system.
This equipment has a 180 psi (1.2 M Pa, 12.4 bar) m aximum working pressure at 180 psi
(1.2 MPa, 12.4 bar) m aximum incoming air pressure.
D Use f luids and solvents that are c ompatible with the equipm ent wetted parts. Refer to the Techni-
cal Data section of a ll equipment manuals. Read the f luid and solvent manufacturer’s warnings.
D Do not use 1,1,1--trichloroethane, methylene chloride, other halogenated hydrocarbon solvents,
or fluids that contain such solvents in pressurized aluminum equipment. Such use could r esult in
a chemical reaction, with the possibility of explosion.
D Handle hoses c arefully. Do not pull on hoses to move equipm ent.
D Route hos es away from traffic areas, sharp edges, moving parts, and hot surfaces. D o not ex-
pose Graco hoses to temperatures above 82_C (180_F) or below --40_ C(--40_F).
D Do not lift pressurized equipment.
D Comply with all applicable l ocal, state, and national fire, electrical, and sa fety regulations.
WARNINGWARNING