Filter
Top Products
—13—
3.3 REFRIGERATING CYCLE
3.3.1 CONDENSER, EVAPORATOR AND
CAPILLARY TUBE(HEAT
EXCHANGE ASSEMBLY)
1. Remove the insulation on the H/E assembly
2. Pierce the pinch-off tube to discharge the
refrigerant, using a FREON
TM
recovery system.
3. After discharging the refrigerant completely,
remove 2 screws between the shroud and H/E.
(See Figure 17)
4. Lift the H/E and open the H/E around 45 degree
clockwise carefully.
5. Unbrace two interconnecting tubes of the
evaporator and condenser carefully.
6. Remove the H/E assembly from the shroud.
(See Figure 18)
7. Unbrace the capillary tube at the connections of
each condenser and evaporator. (See Figure 19)
8. Remove 4 screws between condenser and
evaporator. (See Figure 19)
Figure 17
Figure 18
Figure 19