Filter
Top Products
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
19
Model Code:
The
timer must have the right model code set
to operate
the water softening system correctly. The correct code setting is
PL31
.
If
is flashing
in the display, do steps 3, 4, 6 and 8 below.
To check for the correct code
setting for your model, and to reset it
if needed, do steps 1, 2, 3, 4, 6 and 8 below.
NOTE:
The hour clock and water measure have factory set default
values. The defaults are: 12 or 24 hour clock
–12
; Gallons or liters
measure
— gallons
.
12 or 24 Hour Clock:
With 12 hr set, all time displays are in standard
clock time …12:00 AM to 11:59 PM. If 24 hr is set, time displays are
in military time …0100 (1:00 AM) to 0000 (midnight). To change
from the 12 hr setting, do steps 1, 2, 4, 5, 6 and 8.
Gallons or Liters Measure:
All water flow rate and usage displays are
in gallons with the default setting. If reset to ,
the same displays are shown in liters. Use steps 1, 2, 4, 6, 7 and 8
to change.
Beginning from the present time display, press and hold in the
SET
button until (or as otherwise set) begins to flash.
Press and hold in the
SET
button again. Either or a
previously set code will appear.
If setting is other than
PL31
, use the UP or DOWN button to set
the correct PL number. The correct setting is
PL31.
Press the
SET
button again, and flashes.
To change the display to use the UP button. Use the
DOWN button to reset to 12 hr.
Press the
SET
button and flashes.
Use the UP button to change to the setting. Use the
DOWN button to return to the gallon setting.
Press the
SET
button a final time to return to the present time
display.
8
7
6
5
4
3
2
1
Setting: Model Code, 12 or 24 Hour Clock and Gallons or Liters Measured
TIME
TIME
RECHARGE
AM
TIME