GE GXSL03C Water System User Manual


 
5
Installation Overview
Installation Instructions.
Important Installation Recommendations
Check with your local public works department for plumbing
codes. You must follow their guides as you install the Water
Filtration system.
Use the Water Filtration system on a potable, safe-to-drink, home
COLD water supply only. The filter cartridges will not purify water
or make unsafe water safe to drink. DO NOT use on HOT water
(100°F max.).
Protect the Water Filtration system and piping from freezing.
Water freezing in the system will damage it.
Your Water Filtration system will withstand up to 125 psi water
pressure. If your house water supply pressure is higher than
100 psi during the day (it may reach higher levels at night),
install a pressure-reducing valve before the system.
WARNING:
Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
GXSL03C (rev. 2) and GXSV10C are certified for cyst
reduction and may be used on disinfected water that
may contain filterable cysts. The water should be tested
periodically to verify that the system is performing
satisfactorily. Small parts remaining after the installation
could be a choke hazard. Discard safely.
Slotted and Phillips screwdrivers
Pliers and adjustable jaw wrench
Hand- or battery-powered drill and 1⁄ 4bit (saddle valve
installation)
Electric drill and drill bit to drill 1–1 1 ⁄4 hole (type as
required) if mounting hole is needed for faucet
CAUTION:
To avoid damaging the sink, consult
a qualified plumber or installer for drilling procedures.
Special drill bits may be needed for porcelain or
stainless steel.
Contents included with the product:
Water filter assembly, including mounting bracket
and screws
Product Literature (Owner’s Manual and Installation,
Product Data Sheet, Owner Product Registration Card)
Water supply/saddle valve
Filtered water faucet for sink or countertop mounting
Electronic indicator faucet base and battery pack
(GXSV10C only)
3
8tubing and fittings to make all needed connections
Sump wrench
Filtered
water faucet
Sink
Battery pack
Hot
Shutoff valve
NOTE: To change the filter
cartridge, you must turn off the
water. A nearby shutoff valve is
convenient. Most sinks already
have shutoff valves on the
supply pipes.
Cold
Water supply valve
Tubing insert
Tubing adapter
Compression nut
Water in
Water out
Tubing
Mounting
screw (2)
Filter I
Filter II
Locate the drinking water
system on the cold water
supply pipe, under the
kitchen and/or bathroom
sink, to filter the cold
drinking water.
Tools and Materials Required for Installation
Read entire manual. Failure to follow all guides and rules could cause personal injury or property damage.
Tubing