Filter
Top Products
Carefully slide the case into the window until
the bottom mounting rail drops into the
channels in the supports. Center the case and
lower the window behind the top mounting
rail. The case should be slightly tilted to the
outside. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Attach the bottom of the case to the support
rail with a Type A screw, 1 on each side.
Extend the left and right accordion panels
to the vertical window sashes, drill 1/8″ pilot
holes, and attach the top corners with 2 Type B
screws. Use an accordion panel clamp on each
lower corner to trap the panels. Drill 1/8″ pilot
holes and attach the panel clamps with Type B
screws.
NOTE: Seal any openings around the case or accordion
panels with sealer or foam gaskets.
C
B
A
Install the Case in the Window
14
Consumer Support Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation Instructions
Window Installation Instructions.
Line up the V-notches in the support rails with
the left and right marks on the stool. Make
sure that the support rail is against the back
of the stool and drill two 1/8″ pilot holes into
the stool through the holes in the head of the
support rail. Attach the supports to the stool
using two Type B screws in each support.
Adjust the leveling bolts against the sill so that
the supports have a slight tilt to the outside.
Use a level; about 1/2 bubble will be the
correct slant to the outside.
NOTE: Use a steel washer between the leveling bolts
and the sill if the sill is weak.
BA
Install the Supports
9
Supports
Sill
Type B
screws
Stool
1/2 bubble
Leveling bolt
Type B
screw
Type B
screw
Panel clamp and
Type B screw
Panel clamp and
Type B screw
Top mounting rail
10