Filter
Top Products
13
Assemble the Supports
Loosely attach a support bracket to a support
rail using 2 Type A screws.
Thread a leveling bolt into the support
bracket. An adjustable wrench may be needed.
Before attaching the support, hold the neck of
the support rail against the back edge of the
window stool.
Adjust the position of the support bracket
inward or outward on the support rail until
the leveling bolt is near the outside edge of
the sill.
NOTE: Make sure that the leveling bolt
will be firmly supported by the sill.
Tighten the Type A screws to secure the
support bracket to the support rail in the
correct position.
Repeat steps A - E to assemble the second
support.
F
E
D
C
B
A
8
NOTE: The support bracket may be attached into either slot in
the support rail, depending on the depth of your window sill.
Type A screws
Support bracket
Support rail
Support bracket
Leveling bolt
Adjust as
needed
Neck of
support rail
Stool
Consumer SupportTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions