Filter
Top Products
Remove the Air Conditioner from the Case
Pull to unlatch the lower corners of the inlet
grille and lift it up and off.
Using the tab, pull up slightly on the filter to
release it and pull it down to remove.
Remove the two grille frame screws.
Pull the grille with
your thumb while
pushing the case
with your fingers.
Push the grille to the
left and raise it up.
Lift the grille frame
up and off.
NOTE: Do not pull the
bottom edge toward you
more than 3 inches or you
may damage the tabs of
the grille.
Remove the two locking screws and locking
brackets from the lower front of the unit.
Remove the screw securing the ground wire to
the right side face of the unit.
Slide the air conditioner from the case by
gripping the base pan handle and pulling
forward while bracing the case.
H
G
F
E
D
C
B
A
3
10
Consumer Support Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation Instructions
Window Installation Instructions.
Screw
Ground wire
Grille frame
screws