Filter
Top Products
Installation Instructions
16
UTILITY CLOSET CONNECTION LOCATIONS
IMPORTANT: Plan and locate plenum, wall plug, drain and
thermostat carefully to avoid interference. Hard-to-reach locations
will make installation and service difficult!
Reference Dimensions
A Thermostat cable: 9
1
⁄2′ long
B Power cord: 60″ long
C Case width and depth: 23
1
⁄8″
D Case height: 31″
E Condensate drain: 3/4″ connector
(Centerline of cutout is approximately 5
1
⁄4″ from
left case wall and 8
1
⁄2″ from back case wall.)
F Typical wall plug: 6″–12″ above case
G Room air sensor kit: 10′ long
Outside wall
Flex duct may be used
for transitions only
Use rigid duct for 90°
bends and tees
F
C
C
D
E
Platform
B
A
230/208 VAC
wall receptacle
or
conduit for direct
connection
G
5
1
⁄4″
8
1
⁄2″