Stovax Medium Wood & Multi-fuel Stove User Manual


  Open as PDF
of 32
 
27
1.4 Using the appliance for the first time:
•Burn at a low output for the first day of use
This allows the seals, fixing glues and paint to fully cure.
1.5 During this time the appliance may give off some
unpleasant odours:
•Keeptheroomwellventilatedtoavoidabuild-upof
fumes.
1.6 Your Stovax dealer can carry out service and maintenance.
2. REMOVAL OF THE LOG GUARD
2.1 See Section 4, Installation Instructions, to remove and
replace the log guard:
3. REMOVAL OF FIRE BRICKS
3.1 See Section 5, Installation Instructions, to remove and
replace fire bricks
4. FITTING AND REMOVAL OF BAFFLE
4.1 See Section 6, Installation Instructions, to remove and
replace the baffles.
5. REMOVAL OF MULTI-FUEL GRATE
5.1 See Section 5, Installation Instructions, to remove and
replace the multi-fuel grate.
6. REMOVAL OF WOOD BURNING TRAY
6.1 See Section 7, Installation Instructions, to remove and
replace the wood burning tray.
7. FITTING A NEW DOOR GLASS
ALL MODELS
PR8078
Door Rope Seal
Fixing Screw
Glass Clamp
Glass Edge Seal Tape
Door Cross
Glass
Door
MAINTENANCE and SERVICING
7.1 To maintain the safe use of your stove you may need to
replace a damaged door glass. To complete this operation:
• Lift the door free of the hinge blocks on the right of the
single door or both side for the double door
• Lie the door on a soft flat surface, to protect the glass and
the paintwork
• Use a 2.5mm A/F hexagon key to remove the exposed
fixing screws in the glass clamp, see Diagram
Theoldglasscanthenbeliftedclearofthedoor.(Note
how the edge sealing tape is fixed.) Remember to dispose
of the old glass safely.
• Clean, and re-paint, the rear of the door if required
• Clean the screws with light oil or WD40® to aid future
removal
• Fit the edge sealing tape to the new glass
• Place the glass into position in the door
• Place the door glass clamp back in to position and re-fix
with the clean fixing screws
7.2 Fit only Stovax Ceramic Glass, which is suitable to use in
high temperature applications.
7.3 Using the appliance with a damaged door glass could cause
dangerous fumes to enter the room, or the stove to over
fire, resulting in damage.
8. FITTING A NEW DOOR SEAL
ALL MODELS
8.1 To maintain the safe use of your appliance you need to
replace damaged or worn door sealing rope. To complete
this operation:
•Removethedoorfromtheappliance,byopening,
removing the hinge pins and lifting the door free of the
hinge blocks
•Laythedoorfacedownonasoftflatsurface,toprotect
the paintwork and glass
•Removetheoldropeandscrapeoldgluefromthe
locating groove
Clean the locating groove with a clean dry cloth to remove
all old dust and debris.
•SqueezeagenerousbeadoffreshStovaxThermicSeal
glue into the rope locating groove
 previous next