Filter
Top Products
17
This should allow full access to all major components.
2.1 Turn the gas supply off at the isolation device. Ensure the
unit is cool.
Use cover material to front of appliance to protect
paintwork etc.
Remove the door and place to one side. (4 nuts).
Carefully remove the ceramic fuel components to a safe
place.
Remove front cover-plate (2 screws).
Remove cover plate fixing bracket (2 wing nuts).
(Small Stoves only)
Unscrew pilot union nut on gas valve. See diagram 4.
2.2 Disconnect thermocouple from gas valve. See diagram 2.
Remove ignition lead from electrode. (Cut cable tie to
ignition lead if required).
1.1 All principal components can be replaced without removing
the stove from its installation, although it will be necessary
to remove the door and ceramic outer casing in order to
access most components. In order to remove the casing, use
the following procedure:
1.2 Remove the door retaining nuts using the tool provided and
place the door to one side.
1.3 Carefully remove the top blanking plate and grille and place
to one side, gently remove the top ceramic panel, see
diagram 1. If the unit has been connected to a top exit flue,
it will be necessary to lift and support the grille and top
ceramic panel whilst removing the outer ceramic
components.
1.4 Gently lift the front ceramic panel, and pull away from the
sub-frame to clear the retaining bolts, see diagram 2.
1.5 Carefully remove the two side panels by lifting, and gently
pulling clear of the retaining bolts, see diagram 3. It may not
be necessary to remove both of the side panels.
1. GENERAL
SERVICING INSTRUCTIONS
REPLACING PARTS
2. BURNER UNIT REMOVAL
4
AR0391
Viewing slot on Marlborough only
1
2
3