Filter
Top Products
11
2009 Electrolux Home Products, Inc. All rights reserved.
(continued)
Operating Instructions, CARE & CLEANING
Clean your air conditioner occasionally to keep it looking new. Be sure to unplug
the unit before cleaning to prevent shock or fire hazards.
CARE & CLEANING
This unit has a filter. Grasp the upper panel tab and take off the filter which behind
the grill of the back panel (Fig.26).
Air Filter Cleaning
Wash the filter using liquid dishwashing detergent and warm water. Rinse filter
thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly
dry before replacing.
Or, instead of washing you may vacuum the filter clean.
If you plan to store the appliance during the winter, cover it with plastic or return
it to its carton.
Winter Storage
Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet
and front may be dusted with an oil-free cloth or washed with a cloth dampened
in a solution of warm water and mild liquid dishwashing detergent. Rinse
thoroughly and wipe dry.
Cabinet Cleaning
Never use harsh cleaners, wax or polish on the cabinet front.
Be sure to wring excess water from the cloth before wiping around the controls.
Excess water in or around the controls may cause damage to the air conditioner.
Fig. 26
Filter
Operating Instructions
HOSES STORAGE:
1. Remove the hose assemblies from the unit and the window slider kit.
2. Remove the adaptor A from the hose assemblies.
3. Slide the adaptor A onto the unit.
4. Shorten the hoses to their original size, and put the window hose kits (hose
and adaptor B) onto the hose holders as shown on fig 25.
When the unit is not in use, the hoses could be stored according to the following
steps:
Fig. 25
ADDITIONAL THINGS
YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in
your control that you should become familiar with.
The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned
off and on quickly. This prevents overheating of the compressor and possible circuit
breaker tripping. The fan will continue to run during this time.
The control will maintain the set temperature within 1 °C, between 17 °C and
30 °C (62 °F and 86 °F).
There is a 2-Second delay for the compressor shutting down when selecting
FAN ONLY/HEAT. This is to cover the possibility of having to roll through to select
another mode.
After a power outage, the unit will memorize the last setting and return the unit to
the same setting once power is restored.
The control is capable of displaying temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other and back, press and hold the "TEMP"
Up ( ) and Down ( ) buttons together for 3 seconds.