Filter
Top Products
30
New Construction Accessories
PDXWS
PDXWSEXT
WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-step process,
then powder coated with a polyester nish and cured in an oven for exceptional
durability. The wall sleeve is insulated for sound absorption and thermal ef-
ciency, 16" High x 42" Wide x 13 3/4" Deep.
DEEP WALL SLEEVE EXTENSION For use when the wall is thicker than 13
1/4”deep. The wall sleeve may be special ordered through your Sales Represen-
tative and will be cut to your specic depth requirements..
PXGA
GRILLE Standard, stamped aluminium, anodized to resist chalking and oxidation.
PXAA
PXBG
PXSC
ARCHITECTURAL GRILLES Consist of heavy-gauge 6063-T5 aluminum alloy:
PXAA – Clear, extruded aluminum
PXBG – Beige acrylic enamel
PXSC – Also available in custom colors.
PXDR10
CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal
draining of condensate or to the rear wall sleeve ange for external draining.
Recommended on all units to remove excess condensate. Packaged in quantities
of ten.
PXSB
DECORATIVE SUBBASE Provides unit support for walls less than six inches
thick. Includes leveling legs, side ller panels and mounting brackets for electri-
cal accessories. Accepts circuit breaker, power disconnect switch, or conduit kit.
RT6
DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single stage heat
for PDE models or single stage cool, dual stage heat for PDH model thermostat
features high/low fan speed switch. Thermostat is hard wired and can be battery
powered or unit powered. Features backlit display and multiple conguration
modes. For use on PD-series Friedrich PTACs and Vert-I-Paks.
PDXRT
REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons
that can be placed over the factory control buttons when a remote wall mounted
thermostat is used. The escutcheon directs the guest to the wall thermostat for
operation and retains the LED window to display error codes and diagnostic
information.
PXSE
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2.4" sleeve
extension attached to the room side of the sleeve to allow for the installation of a
PD-Series Friedrich PTAC in a T-Series sleeve.
PDXDAA
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP unit and provides a
transition to direct up to 35% of the total CFM to a secondary room, either left or
right of the unit. Kit includes duct plenum with discharge grille and internal bafe,
adapter and end cap.
PDXDEA
LATERAL DUCT EXTENSION A three-foot insulated plenum that attaches to
the left or right side of the duct adapter. The extension can be cut to length by the
installer. Maximum allowable straight extension is 15 feet.
Accessories
FRP029