Filter
Top Products
26
920-087-04 (3-05)
ADDITIONAL ACCESSORIES
MODEL NUMBER DESCRIPTION PHOTO
PXSE
SLEEVE EXTENSION RETROFIT KIT G-90 zinc coated
steel, 2.4" sleeve extension attached to the room side of the
sleeve to allow for the installation of a P-Series Friedrich
PTAC in a T-Series sleeve.
PDXDA
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP
unit and provides a transition to direct up to 35% of the total
CFM to a secondary room, either left or right of the unit. Kit
includes duct plenum with discharge grille and internal baf fl e,
adapter and end cap.
PDXDE
LATERAL DUCT EXTENSION A three foot insulated
plenum that attaches to the left or right side of the duct
adapter. The extension can be cut to length by the installer.
Maximum allowable straight extension is fi fteen feet.
PXDL
CONTROL DOOR LOCK KIT Locks control door to
prevent tampering by unauthorized users
PDXFT
REPLACEMENT FILTER PACK These are original
equipment return air fi lters. They are reusable and can be
cleaned by vacuuming, washing, or blowing out, and are sold
in convenient ten packs. (Two fi lters per chassis)
PXCJ
CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit
with junction box for 208/230V and 256V units (subbase not
required). Kit includes a means of quick disconnect for easy
removal of the chassis. *Required for 265V installations.
PXPC
15/20/30
POWER CORD RETROFIT Replaces LCDI power cord on 230V
models when unit is used with a subbase. PXPC15 is used with
15 amp 2.5 kW units. PXPC20 is used with 20 amp 3.4 kW
units. PXPC30 is used with 30 amp 5.0 kW units.
CHASSIS OPTIONS
DESIGNATOR DE SCRIP TION
S
STANDARD UNIT Standard PTAC/PTHP chassis. Can be 230/208V or 265V, electric or heat pump.
C
SEACOAST PROTECTION Additional protection for PTAC/PTHP units in a coastal or corrosive
environment. The entire outdoor coil is submerged in a specially formulated enamel coating, then oven-
cured for a tough, corrosion-resistant fi nish.
PXSE
PDXDA
PDXFT
PXDL
M
ad
e in
U
S
A
F
R
45
48
3
21
PXPC30
PXCJ